PANNEAU SILICATE DE CALCIUM 1200 X 600 EP 25 MM

PANEL SILICATE CALCIUM 1000 X 500 IN 25 MM

Ref : PANSIL25

Signs of calcium silicate are obtained by pressing.

This manufacturing process gives the material an exceptional resistance to crushing.

However if the material is stressed beyond these characteristics, there is warping or sagging, but a total destruction of the material.

For use primarily on the furnace walls in cold faces.

It should therefore observe the following precautions:

1 - The surface must be flat to prevent distortion under heavy load (more than 15 kg/cm2).

2 - If the support is deformed, it is necessary to avoid bending.

3 - In case of anchors, tubes, supports, or pass through any metal panels, the holes should be an upper section of 2 to 4 mm.

4 - It is better to ask panels of calcium silicate dry without glue or cement to depermettre without any constraint dimensional change.

Maximum temperature 1100 ° C.

Dimensions 1000x500 - Thickness 25mm